IMPORTANT: IF YOU DECIDE TO BRING YOUR PROJECT HOME AFTER THE EVENT
INSTEAD OF LEAVING IT TO SOLIDIFY
**READ ALL THE INSTRUCTIONS BELOW**
Before the Event:
Make space in your car. It cannot be placed on a seat.
The epoxy will move if it is not completely level
It may be transported flat in your trunk or flat on the floor.
The box should be secured so that it doesn't slide when you stop short or for lights etc.
Once you get home:
Bring the box inside and place it in a safe area at room temperature to cure.
Check the project to make sure nothing has shifted. You will still be able to gently move
items back in place.
It will be partially cured overnight but takes 3 days to completly cure to its hardest state.
After 3 Days:
Because the project is put in the box while still wet there is the possibility that you will have excess epoxy that has hardened around the edges of the
shape and must be removed.
The safe way to remove it is to sand it off by hand or with a dremel. *A MASK IS REQUIRED WHEN SANDING EPOXY
Caution: Do not use scissors, a box cutter or razor to remove. The safest way is sanding while wearing a mask.
Although the epoxy is food save when it is cured the powder reeased when sanding is toxic and should not be breathed in.
A mask is a must.
move around if you stop short or for a light etc.